Resonance / A listening lesson

Standing waves: patterns that fit

See why boundaries select a sequence of resonant modes.

A pattern from travelling waves

When waves travel in opposite directions and combine at matching frequencies, they can form a standing pattern. Some points remain still while others oscillate strongly. A node is a point of zero motion for the quantity being plotted; an antinode is a point of maximum variation. The pattern can look stationary even though energy and material motion are involved.

Evidence: 1

A fixed string gives a clear example

An ideal string fixed at both ends must have displacement nodes at those ends. Its lowest mode fits half a wavelength along the string. The next mode fits one whole wavelength, and higher modes fit more half-wavelengths. With the same wave speed for all modes, their frequencies form integer multiples. Stiffness, nonuniformity and real supports can modify this ideal picture.

Evidence: 2

The plotted quantity matters

An air-column pressure node is not the same thing as an air-motion node. At an ideal open end, pressure variation is approximately small while air motion can be large. At a rigid closed end, air motion is constrained while pressure variation can be large. Lab drawings must identify pressure or displacement; otherwise an apparently reversed node diagram can be perfectly correct.

Evidence: 3

A useful musical prediction

Halve the effective length of an ideal fixed string while keeping tension and mass per length constant. Its fundamental doubles. Change an ideal open-open air column to open-closed at the same length and the fundamental changes for a different reason: the allowed boundary pattern now fits a quarter wavelength. Those are distinct physical operations, even though both can alter pitch dramatically.

Evidence: 2

Ideal fixed string

λₙ = 2L/n and fₙ = nv/(2L), for mode number n = 1, 2, 3… and string wave speed v. These assume a uniform, flexible string with fixed ends.

Keep this in mind

Standing modes are selected by boundaries, and “node” always refers to a specified physical quantity.

Make the connection

A length becomes a note

Compare the first three listed mode frequencies and relate them to the boundary patterns described here.

Open the experiment ↗

Useful words

Antinode

A location of maximum oscillation amplitude in a standing-wave mode. Specify whether the oscillating quantity is pressure or displacement.

See in glossary ↗
Mode of vibration

A characteristic pattern in which a system can vibrate, with an associated resonance frequency and spatial distribution.

See in glossary ↗
Node

A location of zero oscillation amplitude in an ideal standing-wave mode. Pressure nodes and displacement nodes occur at different locations in an air column.

See in glossary ↗
Standing wave

A spatial vibration pattern formed by interacting waves under boundary conditions, with stationary nodes and antinodes in the ideal case.

See in glossary ↗

Sources & further reading

These sources support the explanations and model assumptions. Recording credits are listed in the listening panels and the source register.

  1. Travelling waves, superposition, reflection and transmission ↗Joe Wolfe / UNSW Physclips · Undated
  2. Strings, standing waves and harmonics ↗Joe Wolfe / UNSW Music Acoustics · Undated
  3. Open versus closed pipes ↗Joe Wolfe / UNSW Music Acoustics · Undated
Full source and rights register ↗