One octave contains 1,200 cents
A cent is one twelve-hundredth of a 2:1 octave. A twelve-tone equal-tempered semitone contains exactly 100 cents. Because cents measure a logarithmic ratio, adding the same number of cents applies the same proportional frequency change at every register. This is different from adding a fixed number of hertz.
Evidence: 1
Small offsets become comparable
A rise from 200 to 202 Hz and a rise from 800 to 808 Hz are both one-percent frequency increases. Each is about 17.23 cents, although their hertz differences are 2 and 8. A tuner displaying cents therefore expresses the offset relative to a target frequency, which must itself be defined by a tuning reference.
Evidence: 2
Read the sign carefully
A positive cent value means the compared frequency is above the reference; a negative value means it is below. Zero cents means the ratio is one, not that the frequency is zero. The logarithm requires positive frequencies. An all-zero signal or silent harmonic mixture has no measurable single pitch merely because an interface retains a frequency setting.
Evidence: 3
A practical comparison
A 3:2 fifth spans approximately 701.96 cents. The equal-tempered fifth spans 700 cents, so the ratio fifth is about 1.96 cents wider. A 5:4 major third is about 386.31 cents, compared with 400 cents for the equal-tempered third. These calculations explain the direction and size of the change without predicting whether you will hear it on a particular device or prefer it in a piece.
Evidence: 2
Convert in either direction
c = 1200 log₂(f₂/f₁). Conversely, f₂ = f₁ × 2^(c/1200). Both frequencies must be positive; reversing their order reverses the sign of c.
Cents measure proportional pitch distance, making offsets comparable across registers.
Make the connection
What does “in tune” mean here?
Read both hertz and cents while switching between the tuning examples.
Open the experiment ↗Useful words
Cent
A logarithmic interval unit equal to one hundredth of a 12-tone equal-tempered semitone. An octave spans 1200 cents.
See in glossary ↗Sources & further reading
These sources support the explanations and model assumptions. Recording credits are listed in the listening panels and the source register.
- Note names, MIDI numbers and frequencies ↗Joe Wolfe / UNSW Music Acoustics · Undated
- Tartini tones and temperament ↗Joe Wolfe / UNSW Music Acoustics · Undated
- Periodicity, period, and frequency ↗Chris Donahue / Carnegie Mellon University · 2026