Sound & vibration / A listening lesson

Amplitude: how large is the change?

Distinguish signal size from pitch and from the experience of loudness.

A size, with a specified quantity

Amplitude describes the size of an oscillation. For a moving string it could be displacement in millimetres. For sound in air it could be pressure variation in pascals. In this site’s synthetic signal it is a dimensionless sample value before playback. These quantities are related through an audio system, but they are not interchangeable. A browser cannot know the sound pressure at your ear from its volume slider.

Evidence: 1

Scale the wave, keep its timing

Multiplying a sine wave by one half makes every peak half as tall without changing the time between peaks. That is an amplitude change without a frequency change. Multiplying a complex wave by one half scales every component equally, preserving their relative strengths. Changing just one harmonic is different: it changes the mixture, and can change timbre as well as overall level.

Evidence: 2

Peak is not average energy

Two waves with the same highest peak can have different average squared amplitudes. A brief spike and a sustained plateau are an obvious example. Root-mean-square, or RMS, amplitude provides another useful comparison by summarizing squared sample values over a specified window. It is a signal measure, not a complete prediction of perceived loudness. Listening comparisons should state whether peak, RMS or another property is controlled.

Evidence: 3

A musical consequence

If you compare a soft tone with a much louder one, the level difference can dominate your judgement of brightness, detail or preference. Begin A/B experiments at a modest fixed volume and focus on the stated change. The labs bound output to avoid numerical overload; they do not calibrate headphones or promise equal loudness for every spectrum. Visual traces and numerical component values let you make the comparison without audio.

Evidence: 4

Two useful measures

Peak amplitude is max |x[n]|. RMS amplitude is √(Σx[n]²/N) over N samples. For an ideal sine wave of peak A, RMS = A/√2.

Keep this in mind

Amplitude measures a signal’s size; loudness also depends on the listener, frequency content and playback.

Make the connection

Build a sound

Change a harmonic while leaving the master volume fixed, then inspect the relative component levels.

Open the experiment ↗

Useful words

Amplitude

The size of a variation from its reference value. For a simple waveform it may mean peak size; the measurement convention must be stated.

See in glossary ↗
Gain

A multiplier or ratio relating an output signal to its input. Increasing digital gain does not specify a calibrated acoustic level at the listener.

See in glossary ↗

Sources & further reading

These sources support the explanations and model assumptions. Recording credits are listed in the listening panels and the source register.

  1. Waveforms: sound as a continuous function ↗Chris Donahue / Carnegie Mellon University · 2026
  2. The basic sinusoid ↗Chris Donahue / Carnegie Mellon University · 2026
  3. Quantization and decibels ↗Chris Donahue / Carnegie Mellon University · 2026
  4. What is a decibel? ↗Joe Wolfe / UNSW Physclips · Undated
Full source and rights register ↗