Sound & vibration / A listening lesson

Phase: where a cycle is now

Find out why equal-frequency waves can reinforce or cancel.

Position within a repetition

Imagine two identical loops being traced at the same speed. If both traces pass their peak together, they are in phase. If one reaches its peak when the other reaches its trough, they are half a cycle apart. Phase describes this position within a repeating cycle. A full turn is 360 degrees, or 2π radians; half a turn is 180 degrees.

Evidence: 1

Add the actual values

When two signals meet in a linear model, add their instantaneous values. Equal-amplitude, equal-frequency sine waves in phase give twice the amplitude. At a half-cycle difference they cancel exactly. Between those settings they partly reinforce. The cancellation requires equal levels and precise timing; it is not a universal mute button for arbitrary sound.

Evidence: 2

Hear the combination, not a moving dot

Changing the starting phase of a single indefinitely sustained sine wave does not change its frequency or magnitude spectrum. The important difference appears when it is compared or combined with another signal. In the phase lab, keep both frequencies identical and vary the relative phase. The summed waveform explains the level change directly; the diagram is an analytical teaching signal rather than a map of your room.

Evidence: 3

From phase to practical sound

A delayed copy of a complex signal has a different phase shift at each frequency. Some components reinforce while others cancel, creating the peaks and notches called comb filtering. The effect can occur when microphones capture related arrivals. One phase number cannot describe every frequency of a time-delayed musical sound, so use the sine-wave experiment as a carefully limited first step.

Evidence: 4

A sum of two equal sine waves

A sin(ωt) + A sin(ωt + φ) = 2A cos(φ/2) sin(ωt + φ/2). The magnitude factor reaches zero at φ = π.

Keep this in mind

Relative phase matters when signals combine; cancellation depends on frequency, level and timing.

Make the connection

Add a wave. Lose the sound.

Hold the frequencies equal and compare 0°, 90° and 180° of relative phase.

Open the experiment ↗

Useful words

Interference

The result of overlapping waves adding at a location. Relative phase and amplitude determine the combined variation there.

See in glossary ↗
Phase

A position within a cycle, often expressed in degrees or radians. Relative phase describes how two cyclic signals align.

See in glossary ↗

Sources & further reading

These sources support the explanations and model assumptions. Recording credits are listed in the listening panels and the source register.

  1. The basic sinusoid ↗Chris Donahue / Carnegie Mellon University · 2026
  2. Travelling waves, superposition, reflection and transmission ↗Joe Wolfe / UNSW Physclips · Undated
  3. Amplitude and phase spectra ↗Chris Donahue / Carnegie Mellon University · 2026
  4. What is a filter? ↗Chris Donahue / Carnegie Mellon University · 2026
Full source and rights register ↗