Envelopes & instruments / A listening lesson

Holding a note is different from ending it

Read sustain and release as separate parts of a sound’s timeline.

Sustain is a level, not a duration

In a conventional ADSR envelope, sustain is the level maintained while the note remains held after attack and decay. It is often given as a fraction of peak amplitude. The performer or sequencer determines how long that held stage lasts. A sustain value of 0.6 does not mean 0.6 seconds; it means a level relative to the chosen peak.

Evidence: 1

Release begins with letting go

Release describes the transition towards silence after the note is released. A short release creates a clean separation; a longer release lets the sound continue after the initiating gesture. In a physical instrument, damping, airflow and body response govern what happens. In a teaching synthesizer, a scheduled amplitude curve governs it. Those two mechanisms can resemble each other without being equivalent.

Evidence: 2

Consider overlapping notes

Imagine a new note arriving every half second. With a release of 0.05 seconds, one voice can end distinctly before the next. With a release extending beyond the next onset, several notes may coexist. That changes the combined harmony and overall signal level. A note-length setting and a release-time setting should therefore be considered together, especially in a sequencer.

Evidence: 3

Use stopping as part of the experiment

Begin a held sound, observe its stable section, and then stop it. A safe teaching instrument stops all active voices and does not leave a tail running after navigation. The drawn envelope describes the selected musical timing, while the master Stop is an overriding transport action. Visual and numerical timing can explain sustain and release even when the audio is muted.

Evidence: 1

Keep this in mind

Sustain is a held level; release is the fade after the note-ending instruction.

Make the connection

The beginning changes everything

Compare a held section with its ending, and inspect the envelope’s labelled times and levels.

Open the experiment ↗

Useful words

ADSR

A synthesizer envelope convention: attack time, decay time, sustain level and release time. The sustain parameter is usually a level, not a duration.

See in glossary ↗
Release

The ending stage after an excitation or key hold stops. In a synthesizer envelope it is often the time taken to fall to silence.

See in glossary ↗
Sustain

The maintained part of a note. In an ADSR envelope, sustain names the level held after decay while the note remains active.

See in glossary ↗

Sources & further reading

These sources support the explanations and model assumptions. Recording credits are listed in the listening panels and the source register.

  1. Envelopes ↗Chris Donahue / Carnegie Mellon University · 2026
  2. Oscillations and simple harmonic motion ↗Joe Wolfe / UNSW Physclips · Undated
  3. Scores versus timbre ↗Chris Donahue / Carnegie Mellon University · 2026
Full source and rights register ↗