Rooms & space / A listening lesson

A room keeps sounding after the source stops

Distinguish many lingering reflections from the decay of the source itself.

A collection of paths

In an enclosed space, sound reflects repeatedly from many surfaces. As paths become numerous and their arrivals overlap, the late sound can be heard as a decaying reverberant tail rather than a sequence of separate echoes. Its behaviour depends on the space, its surfaces and the positions of source and listener. A room does not simply add one delayed copy.

Evidence: 1

What reverberation time describes

A commonly used descriptor, RT60, is the time associated with a 60 dB decay in sound level after excitation stops. Measurements may estimate it from a shorter decay range under specified methods. It is frequency-dependent, and one overall value cannot capture every aspect of clarity or spaciousness. A long tail can support sustained music while obscuring rapid articulation in another setting.

Evidence: 2

Source decay and room decay are separate

A plucked string may fade at the source while the room also stores and releases acoustic energy. Extending a synthesizer’s release makes the source last longer; it does not create a room’s many directions and frequency-dependent reflection paths. The envelope lab is useful for comparing duration, but its long release must not be labelled a measured hall reverberation.

Evidence: 3

Make a simple prediction

Imagine a rapid phrase of four short notes. A longer tail lets energy from earlier notes overlap later ones, which can blur their separation or create a desired continuity. Now imagine a single sustained chord: the same persistence may be welcome. The musical consequence depends on the material. Use timing values and source-versus-room distinctions before judging a space as simply good or bad.

Evidence: 1

A limited room estimate

Sabine’s approximation is RT60 ≈ 0.161 V/A seconds for V in m³ and equivalent absorption area A in m². It assumes an approximately diffuse field and is not reliable for every small or highly absorptive room.

Keep this in mind

Reverberation belongs to the space’s response; a long source envelope is a different cause of persistence.

Make the connection

The beginning changes everything

Compare short and long release as a timing analogy, keeping in mind that this does not simulate room reflections.

Open the experiment ↗

Useful words

Reverberation

A decaying field of overlapping reflections after and during a source sound, typically perceived as a continuation rather than separate repeats.

See in glossary ↗
RT60

The time for a reverberant sound level to fall by 60 dB after excitation stops. A stated frequency band and measurement method matter.

See in glossary ↗

Sources & further reading

These sources support the explanations and model assumptions. Recording credits are listed in the listening panels and the source register.

  1. Fundamentals of Sound: Architectural Acoustics ↗AcousticsLab / Pantelis Vassilakis · Undated
  2. Acoustics of Schools: a design guide ↗Institute of Acoustics and Association of Noise Consultants · 2015-11
  3. Envelopes ↗Chris Donahue / Carnegie Mellon University · 2026
Full source and rights register ↗