Pitch & listening / A listening lesson

What a listening experiment can tell you

Separate the model’s output from the limits of ears, devices and browser playback.

No single hearing range fits everyone

Introductory descriptions often summarize human hearing as roughly 20 Hz to 20 kHz. That is a broad reference range, not a promise that every listener hears every frequency within it. Sensitivity depends on frequency and level and varies among people. Age, past exposure and other factors can influence it. This site does not test or diagnose any of those differences.

Evidence: 1

The playback chain matters

A calculated 100 Hz tone must still pass through browser audio, operating-system volume, an amplifier and a transducer. Small speakers can reproduce low frequencies weakly. A numerical spectrum in the lab describes its generated signal, not a microphone measurement of the sound at your ear. Silence or weakness in a particular example therefore cannot identify which part of that chain is responsible.

Evidence: 2

Use a comfortable task

Begin at a modest volume with a mid-register example and change one parameter at a time. The aim is to notice a contrast, not to reach an audible threshold. Avoid escalating volume to find the highest or lowest tone you can detect. The obvious Stop and volume controls are part of the experiment, and the numerical alternatives make audio optional.

Evidence: 1

Observations can still be useful

Record a cautious statement: “With this device and setting, the second tone seemed softer.” That is more defensible than “the second tone contains less energy” or “my hearing is damaged.” The waveform, component table and frequency values establish what changed in the teaching signal. Listening adds your observation under current conditions. Comparing the two helps you distinguish a physical calculation from an inference about perception.

Evidence: 3

Keep this in mind

Use these labs for controlled contrasts, not hearing tests or calibrated sound measurements.

Make the connection

Same pitch, different shape

Choose a comfortable middle frequency and compare waveforms; use the visual values when audio is unavailable.

Open the experiment ↗

Sources & further reading

These sources support the explanations and model assumptions. Recording credits are listed in the listening panels and the source register.

  1. Equal loudness contours and audiometry ↗Joe Wolfe / UNSW Music Acoustics · Undated
  2. What is sound, physically? ↗Chris Donahue / Carnegie Mellon University · 2026
  3. Waveforms: sound as a continuous function ↗Chris Donahue / Carnegie Mellon University · 2026
Full source and rights register ↗