Strings & electronics / Sound-production study

Electric guitar

A magnetic pickup turns a moving string into a signal, and the amplifier becomes part of the instrument.

A solid-body electric guitar has two pickups beneath its strings and a cable leading to an amplifier.

How it makes sound

A pickup turns string motion into a signal; a loudspeaker turns the amplified signal back into moving air.

Moving strings
A pluck sets the magnetically responsive strings vibrating.
Magnetic pickups
Changing magnetic flux produces an electrical signal in a pickup coil.
Amplifier and speaker
Electronic processing shapes the signal before the loudspeaker radiates sound.

From steel string to loudspeaker

An ordinary magnetic pickup combines a magnet with a coil of wire. A suitable vibrating metal string changes the magnetic field linked to that coil, producing an electrical signal. The pickup is therefore a transducer: it changes one kind of physical variation into another. The signal travels through controls and an amplifier before a loudspeaker moves the air that reaches your ears.

The string still behaves as a mechanical resonator. Fretting, plucking and damping matter before the signal encounters any electronics. A pickup does not listen to the room like a microphone. Its position relative to the string’s vibration patterns contributes to the balance of components that it senses.

Evidence: 1 · 2 · 3

One note, several signal paths

Compare the same plucked note through a clean signal path and through a path that strongly changes its waveform. If the electronics cease to scale their output proportionally with input, they can introduce additional frequency components. This is why turning an overdriven sound down after the distortion need not restore a clean tone: the shape has already changed.

The musically useful distinction is between louder and spectrally different. A reliable comparison holds playback level steady enough that a louder example does not automatically seem more forceful or detailed. Also remember that a long electronic tail does not tell you how long the original string was vibrating. Effects and acoustic feedback can change the entire event.

Evidence: 1 · 4

Inspect a simpler version

Choose a sine wave and then a harmonic-rich wave in the waveform lab. Keep frequency and master volume fixed and inspect the spectrum alongside the sound. This demonstrates how differently shaped periodic signals can share a repetition rate while containing different upper components.

The exercise is not a magnetic-pickup or amplifier simulation. It omits pickup position, coil response, cabinet filtering and the feedback between loudspeaker and string. Its purpose is narrower: to make a change in waveform and spectrum intelligible. When comparing real electric-guitar sounds, specify the complete chain and the playing gesture rather than assigning every difference to the guitar body.

Keep this in mind

On an electric guitar, string motion, sensing and signal processing are separate contributors to the sound.

Make the connection

Same pitch, different shape

Compare a sine and a harmonic-rich waveform at the same fundamental frequency.

Open the experiment ↗

Sources & further reading

These sources support the explanations and model assumptions. Recording credits are listed in the listening panels and the source register.

  1. The Structure of the Electric Guitar: What kind of instrument is an electric guitar? ↗Yamaha Corporation · Undated
  2. The Structure of the Electric Guitar: What are pickups? ↗Yamaha Corporation · Undated
  3. Strings, standing waves and harmonics ↗Joe Wolfe, UNSW Music Acoustics · Undated
  4. Waveshaping, The Theory and Technique of Electronic Music ↗Miller Puckette, University of California San Diego · Undated
Full source and rights register ↗